Soundstream BXA1-10000D Monoblock 10,000 Watts Bass Equalizer Epicenter Amplifier
- SKU #: 02326
Sweep selects the frequency boosted by the equalizer. This is the "center frequency", which can be as low as 27Hz, or as high as 63Hz. Choosing this frequency depends on your taste in music.
Width increases or decreases the bandwidth range, or "Q" boosting frequencies near the "center frequency". Narrow Q focuses on harmonics immediately surrounding the center frequency. Wide Q unlock harmonics all around the center frequency.
Output Voltage is the amount of boost level. Your instincts might be to choose 10V because why not, but hold on a second... more isn't necessarily better. In this case, more can be dangerous, potentially damaging your subwoofers.
Max Bass Indicator lights above the equalizer controls is a visual representation of the boost level. Bright, continuous illumination indicates maximum bass enhancement levels have been reached. Remember, more isn't necessarily better...
1-Ohm Minimum Impedance Stability. An amplifier's impedance stability is its ability to continuously power speaker(s) of no less than the given impedance per channel, without the risk of damage. Subwoofers are available in a variety of voice coil configurations and impedances, so be sure yours will be no less than 1-ohm.
Low Level RCA Input and Pre-Amp Output. Connect the low level (pre-amp) audio output of the car stereo to the amplifier, using good quality twisted pair RCA interconnect cables. The amplifiers pre-amp output daisy-chains the audio signal to multiple amplifiers of complex audio systems.
Active 12dB/Octave Crossovers and Phase Shift. Active crossovers built into an amplifier are the most efficient type of crossovers to use in car audio systems. Active crossovers protect speakers from damage by harmful frequencies, and preserve optimum performance.
Dash Mount Control included with this amplifier can be mounted anywhere in the vehicle, but near the driver seat is recommended. The output level of the Bass Equalizer can be controlled, as well as the amplifier's gain level.
- Power Handling:
- 1,400W x 1 at 4-Ohm Mono
- 2,100W x 1 at 2-Ohm Mono
- 3,300W x 1 at 1-Ohm Mono
- 10,000W Max Power
- Variable 40-150Hz 12dB Low Pass Crossover
- Variable 10-50Hz 12dB Subsonic Crossover
- Selectable 180degree Phase Shift
- Total Harmonic Distortion: < 0.3%
- Frequency Response: 15-500Hz
- Signal-to-Noise Ratio: 105dB
- Input Sensitivity: 200mV - 6V
- Dimensions: 8.125" W x 2.125" H x 19.75" L
Special Price $519.99
Special Price $2,969.99
Special Price $268.99
Special Price $139.99
Special Price $299.99