Memphis VIV600.4v2 4-Channel 1200W Max Amplifier
- SKU #: 03382
Description:
The folks at Memphis Audio are so proud of these amplifiers, they named the line after the year their company was born — 1965. Looking fine in its anodized brushed aluminum chassis, the SixFive Series VIV600.4V2 four-channel amp can send 80 watts RMS to each of your front and rear full-range speakers. Into bass? You can bridge this amp to 2-channel mode, and drive a couple of subs with 300 watts each. You can even change the color of the amp's illuminated logo — select one of the seven available colors to match your mood, whim, or vehicle's interior.
This versatile amp features onboard digital signal processing — including high-pass, low-pass, and bandpass filtering — that makes it useful in a variety of systems.
2-way system: the amp's front channels drive a pair of tweeters, with a high-pass filter set to keep damaging low notes away. The rear channels drive a pair of woofers, with a low-pass filter set so the correct bass frequencies go their way. You can tweak the crossover settings to get the sound to fit your specific tweeters and woofers best.
3-way system: the tweeters are run the same way with the front channels, while you'd use the rear channels to power the midrange drivers, using a bandpass filter to eliminate the extreme highs and lows, allowing the midrange to play clearly. You'd use a separate amplifier to power the low-frequency speakers or subs in this type of system.
A bass boost lets you add some extra pop to the bottom end. Speaker-level inputs and automatic turn-on circuitry allow you to connect this amp into almost any system, including ones using the factory radio. Preamp outputs can be used to feed a subwoofer amp its input signal in a 3-way system. A magnetic cover protects the control panel from dirt and other accidents.
Features:
- Brushed anodized aluminum gunmetal finish
- 7-Color selectable LED logo and ground lighting end caps
- Reversible LED logo accent strip
- Ultra-efficient full range class D topology
- Bass boost up to 18dB
- HP/LP filters on all channels with 2 channels including BP filter
- DSP with 24 dB crossover slopes (400.4V2, 600.4V2, 750.6V2)
- MONO Amps Only:
- DSP with 48 dB crossover slopes (low pass only)
- Optional wireless bass remote w/ improved response VIVREMV2
- M-Equalization allows Bass Boost, Freq and Q to be dialed in
Specifications:
- 4-channel car amplifier
- 80 watts RMS x 4 at 4 ohms (150 watts RMS x 4 at 2 ohms)
- 300 watts RMS x 2 bridged at 4 ohms (4-ohm stable in bridged mode)
- Class D amp technology
- front channels:
- variable high- or low pass filter (10-5,000 Hz, 24 dB/octave)
- rear channels:
- variable high-pass filter (10-500 Hz, 24 dB/octave)
- variable low-pass filter (50-5,000 Hz, 24 dB/octave)
- bandpass filter engages both
- variable bass boost (0-18 dB at 45 Hz) on front and rear channels
- preamp inputs and outputs
- speaker-level inputs (require speaker wire to RCA adapters)
- hinged magnetic cover plate conceals top-mounted controls
- 7 color selectable LED logo
- 8-gauge power and ground leads and a 40-amp fuse recommended — wiring and hardware not included with amplifier
- no onboard fuses — when installing multiple amps in a system, an additional 40-amp in-line fuse between the distribution block and this amplifier is recommended
- dimensions: 10-15/16"W x 2-1/4"H x 8-1/4"D
Additional Information
-
Hertz SV200L 8" 250 Watts RMS SPL Show Series Woofers
Special Price $299.99
Retail: $425.99
-
DSR1 - Rockford Fosgate Digital Sound Processor with Maestro AR Amplifier Replacement Module
Special Price $349.99
Retail: $384.99
-
Hertz MPG-165.3 6.5" Protective Cover Grills for Component / Coaxial Speakers
Special Price $39.99
Retail: $75.99
-
Memphis MXA82TG 8" 150W RMS Marine Tower Speakers (Gray)
Special Price $959.99
Retail: $1,209.99
-
Hertz HRC BM Bass Remote Control for ML Power 1 and ML Power 5
Special Price $45.99
Retail: $49.99