DC Audio 7.5K Monoblock 7500W RMS Amplifier

The 7.5K competition series amplifier is a 7,500 watt mono block. It is capable of running up to 18 volts for up to 9,200 watts. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped.

It comes with a bass knob and a clipping indicator. For power inputs it will accept dual 0 AWG for power and dual 0 AWG for ground.

Features:

• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Dual 0 AWG power and ground inputs (both must be used)

Specifications:

• Output Power:
• 2,000W x 1 at 4-Ohm 14.4V
• 4,400W x 1 at 2-Ohm 14.4V
• 7,500W x 1 at 1-Ohm 14.4V
• 8,600W x 1 at 1-Ohm 16V
• 9,200W x 1 at 1-Ohm 18V
• Input Sensitivity: 6V - 0.2V
• Low Pass Filter (at 24dB Slope): Switchable Variable 35 - 250Hz
• Subsonic Filter (at 24dB Slope): Switchable Variable 10 - 50 Hz
• Bass Boost: 0-9dB Variable
• Frequency Response: 15-270 Hz
• Signal to Noise Ratio: 100 dB
• Damping Factor: 150<
• Efficiency at 4-Ohm: Over 90%
• THD at 4-Ohms: Less than 0.1%
• Fuse Rating: 750 Amps
• Lined Fuse Rating: 1,500 Amps
• Indicator: Power, Protection
• Speaker and Power Terminal: Mold Type
• Heatsink Length: 32.28"

Install Recommendations:

• 1 upgraded battery under the hood
• 3 extra 800ci battery in the rear
• Minimum of two 0 awg ran from the front battery to the rear battery
• Both 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 4 runs into the amp
• 2 Upgraded aftermarket alternators
• Dash mounted voltage meter
• Weight: 52LB