C2R-CHY4 - PAC Radio Replacement Interface for Select Chrysler, Dodge and Jeep Vehicles

The PAC C2R-CHY4 allows for the installation of an aftermarket radio in 2005-2009 Chrysler, Jeep, and Dodge vehicles utilizing the CAN Bus data system. The C2R-CHY4 is packaged with both Chrysler harnesses for an all-in-one radio replacement solution. The interface provides a data controlled accessory output wire and all the necessary output wires for a navigation radio install. When retaining the use of the factory steering wheel controls, the C2R-CHY4 provides a SWC Output connector for direct plug and play connectivity to all SWI-modules (SWI-X, SWI-JACK, SWI-PS, SWI-ECL2).

• Replacement interface harness for select Chrysler vehicles with CAN Bus
• Compatible with amplified or non-amplified systems
• No longer requires the use SWI-CAN Module to retain steering wheel controls
• Retain Accessory Power (RAP) 12V Output
• VSS, illumination, parking brake and reverse trigger output
• Digital amp turn-on

• Dodge:
  • 2007 - 2008 Avenger
  • 2004 - 2008 Durango
  • 2005 - 2008 Magnum
  • 2005 - 2008 Dakota
  • 2005 - 2008 Charger
  • 2005 - 2008 Grand Cherokee
  • 2005 - 2008 Commander
  • 2006 - 2009 Ram Pickup
  • 2006 - 2008 Caliber
  • 2008 - 2009 Challenger
  • 2009 Journey
• Chrysler:
  • 2007 - 2008 Aspen
  • 2007 - 2008 PT Cruiser
  • 2008 Caravan
  • 2007 - 2008 Sebring
• Jeep:
  • 2007 - 2008 Compass
  • 2007 - 2008 Patriot
  • 2007 - 2009 DTS

• Yellow – 12V Constant
• Red – 12V Accessory
• Black - Ground
• Orange – Dash Light Dimmer/Illumination
• Green – Left Rear Speaker (+)
• Green with Black Stripe Left Rear Speaker (-)
• White – Left Front Speaker (+)
• White with Black Stripe – Left Front Speaker (-)
• Purple – Right Rear Speaker (+)
• Purple with Black Stripe – Right Rear Speaker (-)
• Gray – Right Front Speaker (+)
• Gray with Black Stripe – Right Front Speaker (-)